Atag VA63313LT Benutzerinformation Seite 13

detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
Setting and starting a
programme
The Auto off function
This function decreases energy
consumption by deactivating automatically
the appliance when it is not operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.
Starting a programme
1. Keep the appliance door ajar.
2. Press the on/off button to activate the
appliance. Make sure that the
appliance is in programme selection
mode.
3. Press the button related to the
programme you want to start.
The related programme indicator comes
on.
4. Close the appliance door to start the
programme.
Starting a programme with
delay start
1. Set a programme.
2. Press repeatedly until the indicator
related to the desired number of hours
is on (3h or 6h).
The delay indicator is on.
3. Close the appliance door to start the
countdown.
While the countdown is running, it is
possible to increase the delay time but
not to change the selection of the
programme and options.
When the countdown is completed, the
programme starts.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for more
than 30 seconds during the
drying phase, the running
programme ends. It does not
happen if the door is opened by
AirDry function.
Cancelling the delay start while
the countdown operates
When you cancel the delay start you have
to set the programme and options again.
Press and hold simultaneously
and until the appliance is in programme
selection mode.
Cancelling the programme
Press and hold simultaneously
and until the appliance is in programme
selection mode.
Make sure that there is detergent in the
detergent dispenser before you start a
new programme.
End of the programme
When the programme is completed the
indicator is on.
1. Press the on/off button or wait for the
Auto off function to deactivate the
appliance. If you open the door before
the activation of Auto off, the appliance
is automatically deactivated.
2. Close the water tap.
13