Technical Information - Electrolux GA60GLVSCN Benutzerinformation

Problem and alarm code Possible solution
The appliance does not
drain the water.
The display shows
The anti-flood device is on.
The display shows
Once you have checked the appliance,
deactivate and activate the appliance. If
the problem occurs again, contact an
Authorised Service Centre.
12.1 The washing and drying results are not satisfactory
Problem
There are whitish streaks or
bluish layers on glasses and
dishes.
There are stains and dry wa-
ter drops on glasses and
dishes.
The dishes are wet.
Refer to "Hints and tips" for
other possible causes.

13. TECHNICAL INFORMATION

Dimensions
Electrical connection
Water supply pressure
Water supply
Capacity
Power consumption
• Make sure that the sink spigot is not clogged.
• Make sure that the drain hose has no kinks or bends.
.
• Close the water tap and contact an Authorised Service
Centre.
.
Possible solution
• The release quantity of rinse aid is too much. Adjust
the rinse aid selector to a lower position.
• The quantity of detergent is too much.
• The released quantity of rinse aid is not sufficient.
Adjust the rinse aid selector to a higher position.
• The quality of the rinse aid can be the cause.
• The programme does not have a drying phase or
has a drying phase with low temperature.
• The rinse aid dispenser is empty.
• The quality of the rinse aid can be the cause.
• The quality of the multi-tablets can be the cause. Try
a different brand or activate the rinse aid dispenser
and use rinse aid and multi-tablets together.
Width / height / depth (mm)
Voltage (V)
1)
Frequency (Hz)
bar (minimum and maximum)
MPa (minimum and maximum)
Cold water or hot water
Place settings
Left-on mode (W)
For alarm codes not described in the
table, contact an Authorised Service
Centre.
2)
ENGLISH
596 / 818-898 / 550
220 - 240
50
0.5 - 8
0.05 - 0.8
max 60 °C
15
0.99
19