Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
A. Front Wheel
1. Inspect all components for damage
2. Remove bolt and washers from end of front axle.
3. Remove front axle from front fork or bag.
4. Insert axle through steering arm bushing and into wheel hub. It may be necessary to align inner wheel spacer between bearings to
allow axle insertion.
5. Install axle and tighten axle bolt and nut until snug.
6. Check wheel rotation
B. Rear Wheel
1. Remove axle nut and washers from end of rear axle.
2. Install rear wheel with valve stem on right side to prevent interference with rear brake.
3. Install axle bolt with washers between bearings and bracket and nut.
4. Check for proper chain and tighten rear axle bolt.
5. Check for free rotation of rear wheel.
6. Check for proper operation of rear brake if applicable.
7. Check for proper drive component operation.
C. Pneumatic Tire Information
• Never use tires or tubes not recommended by us or exceed the maximum P.S.I. limits of the tire assembly in use.
WARNING: Tire wear, punctures, or ruptures can cause immediate loss of con- trol, which may affect operator and precipitate
serious bodily injury. Helmets, goggles, gloves, elbow and knee pads and appropriate shoes with ankle support must be
worn at all times.
WARNING: Patching a tube is an emergency repair. Patches can severely weaken the integrity of a tube, resulting in possible tube
failure, cause a loss of control, and cause the rider to fall. Replace a patched tube as soon as possible. Never replace the tube
with anything other then the stock OEM tube. Using an after- market tube or tire not intended for our specification could result in a
sudden loss of pressure that could cause damage to your scooter and/or a loss of control.
CAUTION: Replace front or rear tires when tread is worn within 1/16" tread depth, or if obvious tire damage has occurred.
14
INsTrUcTIoNs
sxT-scooTErs
Werbung
Inhaltsverzeichnis
