SXT-Scooters COMPACT H300 Bedienungsanleitung Seite 26

Secure Handlebars:
4. Locate the Foam Grips. (They are hanging from the Handlebar at the top of the Steering
Column on elasticcords). Pick up the right hand Foam Grip and insert the metal shaft
into the hole on the right side of the handlebar. Rotate the Foam Grip forward/clockwise
until you hear a click and the Battery Gauge is in view facing upward. (Fig. D)
5. Locate the spring-loaded Handlebar Button. (This pencil eraser-sized button is located
on the metal shaft part of the foam grip.) Press in the Handlebar Button with your
thumb, while sliding the foam grip into place with your other hand.
The Handlebar Button will click/lock into place in a small hole in the Handlebar. Repeat
the same procedure for the left hand Foam Grip with the Brake. (Fig. E)
Extend Steering Column:
6. Locate the Steering Column Nut. (This is a large, 1 1/2" diameter nut located at the
base of the Steering Column.) Loosen/turn the Steering Column Nut counterclockwise.
Slowly pull the Steering Column upward until it is fully extended and clicks/locks into place.
IMPORTANT: THE STEERING COLUMN MUST BE FULLY EXTENDED AND
LOCKED INTO POSITION FOR SAFE USE.
7. Tighten/turn the Steering Column Nut clockwise. It should be tightened very firmly by
hand. (Fig. F) Do not use a wrench or other tool to tighten.
The setup of your electric scooter is now complete. Please read the
following information prior to using your electric scooter for the
first time.
Survey the Landscape:
Find a safe, clear, smooth area that is free of pedestrian and vehicular traffic.
Turn the Power "ON": IT IS HIGHLY RECOMMENDED TO FULLY CHARGE THE BATTERY
PRIOR TO EXTENDED USE. Locate the "ON/OFF" (Power) Switch under the Deckboard,
on the right side, and turn the unit "ON." You will see a green light on the Speed Controller.
(Fig. G)
IMPORTANT: ALWAYS TURN THE POWER "ON" BEFORE RIDING.
NEVER OPERATE THIS VEHICLE WITH THE POWER SWITCH IN THE "OFF"
POSITION OR YOU MAY DAMAGE THE ELECTRONICS.
You can operate your electric scooter alternately as a push scooter and as a motorized
electric scooter, as long as the power switch is turned "ON" prior to any use.
Practice pushing yourself around: From the Kickstand Position, place your electric scooter
into Riding Position by pushing the Handlebars forward until the Folding Lever locks into
place. Your into Riding Position by pushing the Handlebars forward until the Folding Lever
locks into place. Your
Get ready...
INsTrUcTIoNs
6
sxT-scooTErs
D
E
F
G