Bosch PST 700 PEL Originalbetriebsanleitung Seite 25

OBJ_BUCH-354-005.book Page 25 Wednesday, February 20, 2008 10:44 AM
Afterwards, push the base plate 5 to the stop in
the direction of the saw blade 10.
PST 670 L: Position the holder for the guide roll-
er 22 in such a manner that the guide roller 9
faces against the back of the saw blade. Precise
cuts are possible only when the guide roller fac-
es tightly against the back of the saw blade.
Tighten the screw 23 again.
The dust cover 11 and the splinter guard 21
cannot be used when performing mitre cuts.
Offsetting the Base Plate (see figures D–E)
For sawing close to edges, the base plate 5 can
be offset to the rear.
PST 670 L/PST 700 PEL: Remove the laser mod-
ule 14, if required.
PST 670 L: Insert a saw blade 10.
Loosen the screw 23 and slide the base plate 5
toward the vacuum connection 4 to the stop.
PST 670 L: Position the holder for the guide roll-
er 22 in such a manner that the guide roller 9
faces against the back of the saw blade. Precise
cuts are possible only when the guide roller
faces tightly against the back of the saw blade.
Tighten the screw 23 again.
Sawing with the base plate 5 offset is possible
only with a mitre angle of 0°. In addition, the
parallel guide with circle cutter 28 (accessory)
as well as the splinter guard 21 may not be used.
Sawdust Blower Device
With the air jet of the sawdust blower device 7,
the cutting line can be kept free of dust and
chips.
Switching on the sawdust blower device: For
cuts in materials with high removal rate, such as
in wood, plastic, etc., push the switch 7 to
position "I".
Switching off the sawdust blower device: For
cuts in metal and when a dust extraction system
is connected, push the switch 7 to position "0".
Bosch Power Tools
Starting Operation of the Power Tool
Observe correct mains voltage! The voltage
of the power source must agree with the
voltage specified on the nameplate of the
machine. Power tools marked with 230 V
can also be operated with 220 V.
Switching On and Off
To start the machine, press the On/Off switch 2.
To lock the On/Off switch 2, keep it depressed
and push the lock-on button 1 to the right or left.
To switch off the machine, release the On/Off
switch 2. When the On/Off switch 2 is locked,
press it first and then release it.
PST 700 PE/PST 700 PEL: After longer periods
of work at low stroke rate, the machine can heat
up considerably. Remove the saw blade from
the machine and allow the machine to cool
down by running it for approx. 3 minutes at
maximum stroke rate.
Controling the Stroke Rate
(PST 700 PE/PST 700 PEL)
Increasing or reducing the pressure on the
On/Off switch 2 enables stepless stroke-rate
control of the switched-on machine.
When the On/Off switch 2 is locked, it is not
possible to reduce the stroke rate.
The required stroke rate is dependent on the
material and the working conditions and can be
determined by a practical trial.
Reducing the stroke rate is recommended when
the saw blade engages in the material as well as
when sawing plastic and aluminium.
1 609 929 L18 | (20.2.08)
English | 25