Werbung
Installation
Wooden walls: Screw in screws directly, if necessary pre-drill
with a wood drill (1.5 mm)
Stone walls: Drill pre-marked holes with a 5 mm masonry drill bit, in-
sert dowels
6. Mount the mounting base using suitable screws
DEU
7. Place the device on the mounting base and snap it into the clamps
ENG
5.2 Mounting using adhesive strips
FRA
NDL
ITA
ESP
DAN
NOR
FIN
1. Select a suitable mounting position
SWE
2. Remove the protective film from one side of the adhesive strip
POL
3. Attach the adhesive strip to the back of the mounting base
26
Depending on the surface, installation can be
performed with double-sided adhesive tape. Instal-
lation is possible on different surfaces as e. g.
masonry, furniture, tiles, or glass.
In case of installation with adhesive strips
the installation surface must be even,
smooth, undamaged, clean, and free from grease
and solvents. Use suitable adhesive strips.
Werbung
