Westermann Cleanmeleon 2 PRO Betriebsanleitung Seite 133

13 Maintenance and servicing
13.6 Changing the gear oil
Oil level
Sequence of
operations:
NOTICE
Cleaning
procedures:
P Dismantle oil filter protection
P Dismantle oil filter
P Allow the oil to drain off completely
P Remove filler plug and oil level check point
P Replace filter element (Art. No.: KT-00-00797)
P Mount oil filter and oil filter protection properly
P Fill up gear oil to the oil level check point
(quantity approx. 2.7l)
-> Oil grade 20W50 standard, 15W50 for colder regions.
P Close check point and filler plug again
-> If necessary, replace sealing ring
Operate the vehicle for approx. 1 minute and check the
oil level again.
Due to the impact air has on efficiency in hydrostatic
drive applications, it is important that it is flushed out
of the system. Air causes inefficiency because its
compression and expansion rate is higher than that of oil
approved for use in hydrostatic drive systems. These flus-
hing operations should always be performed when a
hydrostatic system has been opened to facilitate mainte-
nance or to change the oil.
Filler plug
Oil level
check point
Oil filter incl.
filter element
Oil filter protection
45