Westermann Cleanmeleon 2 PRO Betriebsanleitung Seite 119

11 Operation
11.2 Start | stop the CM2 PRO GXV engine
Before starting the engine, make sure that all controls are in their neutral
positions to prevent uncontrolled starting of attachments. Then observe the
following steps:
11.2.1 Starting the engine
Start engine
- Lift the throttle rod and pull out to behind the guide nut
securing over the keyhole plate (choke position).
- After the engine has warmed up, briefly raise the throttle lever again
and insert between the two nuts
Stop engine
- Lift the throttle rod and push it back as far as it will go.
11.2.2 Starter cord
(Fig. 9 - Starter cord)
2
1
(Fig. 8 - Starting the engine)
+
1
In case of failure of the electric start due, for
example, to insufficient battery voltage.
P Lift the engine cover
P Push the throttle lever into the foremost
position.
P Strongly pull the starter cord directly at the
engine until the machine starts.
2
before
2
31