Dometic AP Remote control Montage- Und Bedienungsanleitung Seite 8

EN
Press the button to save the currently locked channel.

Channel P appears on the display, and the selected channel is
locked in.
8.5 Additional blind operation
To operate a Venetian blind proceed as follows:
Press the button briefly to tilt the slats up.
Press the button briefly to tilt the slats down.
Long press the button to stow the blind.
Long press the button to deploy the blind.
Press the button to stop the blind moving.
8.6 Changing batteries
NOTE
Do not mix battery types.
Replace both batteries at the same time.
Remove batteries when the AP remote control will be le
unused for long periods.
Change the batteries as shown:

9 Troubleshooting
Problem Possible cause
Blind does not re- No power
spond to the AP re-
mote control.
Wrong channel
Repeated or pro-
longed use can cause
the thermal cut-out to
activate.
8
Suggested remedy
Check battery.
Check power to
the blind.
Check channel
number.
Wait 20 min for
the motor to re-ac-
tivate.
Problem Possible cause
Wrong or lost pairing
Blind moves in the Wrong setting
wrong direction.
More than one blind When set to chan-
moves. nel P, all channels will
operate at the same
time.
Multiple blinds can
be paired to each
channel.
Display does not No power
show the channel
number.
Programming prob- AP remote control
lems. does not behave as
expected.
10 Cleaning and maintenance
NOTICE! Damage hazard
Never clean the device under running water or in dish
water.
Do not use sharp or hard objects, abrasive cleaning
agents or bleach during cleaning as these may damage
the device.
Occasionally clean the product with a damp cloth.
11 Warranty
The statutory warranty period applies. If the product is defective,
please contact the manufacturer's branch in your country (see
dometic.com/dealer) or your retailer.
For repair and warranty processing, please include the following
documents when you send in the device:
• A copy of the receipt with purchasing date
• A reason for the claim or description of the fault
Note that self-repair or nonprofessional repair can have safety
consequences and might void the warranty.
12 Disposal
Place the packaging material in the appropriate recycling waste
bins wherever possible.
If you wish to finally dispose the product, ask your local
recycling center or specialist dealer for details about how
to do this in accordance with the applicable disposal
regulations.
Suggested remedy
Re-pair AP remote
control to the
blind.
Change direction
of blind.
Change channels
to control other
blinds.
Un-pair unwanted
motors from the AP
remote control.
Check battery.
Note that the sys-
tem will automatically
switch out of program-
ming mode if no but-
tons are pressed after
30 s .
Do not leave big
delays between
programming
steps.