Dometic AP Remote control Montage- Und Bedienungsanleitung Seite 5

MOTOR SETTING
Press and hold the
the blind jolts once.

CODE
Press and hold the
control until the blind jolts once.

Changing the direction of the blind
Ensure that only the blind being paired is connected to the power
supply and any other blind is disconnected.
Select the desired channel using the channel selector.
on page 4
SET
Press and hold the button on the back of the remote control
until the blind jolts once.

Press the button until the blind jolts once.

Setting top and bottom stops
Select the desired channel using the channel selector.
on page 4
button on the blind until
button on the back of the remote
Press the

Press the
position.

Press and hold the
until the blind jolts once.

Fig. 
Press and hold the

Press the

Press the
position.

Fig. 
button to deploy the blind.
button near the midpoint to set the lower stop
SET
button on the back of the remote control
button until the blind jolts once.
button to stow the blind.
button to stop the blind in required top stop
EN
5