Dometic AP Remote control Montage- Und Bedienungsanleitung Seite 6
Vorschau ausblenden
Andere Handbücher für AP Remote control:
- Montage- und bedienungsanleitung (109 Seiten)
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
EN
Press the
button and the
the top stop position.
The blind will move down slightly.
Press the
button to deploy the blind.
page 5
Press the
button at the required bottom stop position.
Fig.
on page 5
Press the
button and the
the bottom stop position.
The blind will move up slightly.
Changing the motor speed
Choose speed setting.
Option
Unrestricted
Slow
MOTOR SETTING
Press and hold the
jolts three times.
Change to tilt mode
Select the desired channel using the channel selector.
on page 4
SET
Press and hold the
button on the back of the remote control
until the blind jolts once.
Press and hold the
button until the blind jolts once.
The blind is now changed to tilt mode.
Repeat these steps to change back to roller mode.
6
button at the same time to save
Fig.
on
button at the same time to save
Description
When set to unrestricted the motor
speed will depend on the supply
voltage and supply cable lengths.
When set to slow the motors on
different blinds will operate at the
same (lower) voltage and will be
more consistent.
button on blind until blind
Fig.
8.4
Pairing and Unpairing Atlantic 12/24 S Motor with AP
Remote Control
These instructions are valid for Skysol powered blinds (PB2),
Romanblinds powered (RB), Venetian blinds powered (VB), Skysol
track small (STS), Skysol track large (STL), Skyscreen powered (SSP)
and Skysol powered roofblind (SPR).
Ensure that only the receiver for the blind being paired is
connected to the power supply and any other blind's receivers are
disconnected.
Select the desired channel using the channel selector.
SET
Press and hold the
button on the receiver until blind jolts
once and a blue light turns on.
CODE
Press and hold
button on the back of the remote control
until blind jolts once.
Changing the direction of blind
Unpair or disconnect any other receivers on the same channel
from the power supply.
Select the desired channel using the channel selector.
SET
Press and hold the
button on the receiver until the blind jolts
once.
Werbung
