Sunrise Medical Empulse R90 Anleitung Seite 3

9
10
Adjustable Spring Stop Detail
Adjust to increase
compression
Adjust to decrease
compression
See page 28 for contact information
or visit www.SunriseMedical.co.uk
5
C. Centering the receiving mount and harware onto wheelchair:
1. Loosen the hardware (9) with 4mm allen wrench so the mount (10)
can be positioned correctly. See Fig 5.
2. Move the mount to the center of the camber tube by measuring
from the mount edge to the side frame of both sides and ensure the
distance is the same.
3. Rotate the mount until level bubble (11) is centered when weight is
added on the chair.
Note: Weight in the chair causes the mount to tilt back slightly.
4. Tighten all six fasteners (9) to 7.8 Nm.
11
D. Removing folding axle assembly:
1. Ensure the power assist module is already removed from the folding
axle assembly (1).
6
2. Grab the folding axle assembly (1) and compress the larger tube
toward the smaller tube until the axle adapter receiver (1) is free of
the folding axle adapter (3).
7 3. Pull the folding axle assembly (1) toward the rear of the chair.
E. Removing the folding axle adapter and hardware from folding axle
assembly (1):
1. Remove hardware (2).
2. Remove folding axle adapters (3) and hardware (2) from axle plates
(4).
F. Adjusting Folding Axle Spring Force
1. Remove both screws (7) using 3mm allen wrench. Use screwdriver to
keep Spring Stop (8) from falling out. See Fig 6.
8
2. To increase spring force move Spring Stop (8) to new hole location
closer to center of assembly. Use screwdriver to align Spring Stop (8)
with hardware (7).
3. Attach both screws (7) to properly hold Spring Stop (8).
4. Attach Folding Axle Assembly (1) onto chair to check spring force.
Adjust as necessary.
R90 FOLDING AXLE ASSEMBLY
®
(FOLDING FRAMES)
INSTRUCTION SHEET
© 2024 Sunrise Medical (US) LLC
2024-07-30 255036-EU Rev.B
ENGLISH
Page 3 of 28