Disassembly And Disposal; Energy Efficiency; Technical Data And Dimensions - Elero Rolmotion/D+ M Nutzungsinformation

Disassembly and disposal

11 Disassembly and disposal
After unpacking, dispose of the packaging in accordance
with the valid regulations.
Dispose of the product in accordance with the relevant
regulations when you no longer need it. Disposal is partially
subject to applicable legal regulations. Bring the product to
be disposed of to authorised collection points only.
Environmental information
No superfluous packaging materials have been used.
The packaging can be easily separated into three material
types: cardboard (box), polystyrene (padding) and polyeth-
ylene (bag, protective foam).
The device is made of materials that can be reused if dis-
mantled by a specialist company. Please note the local
regulations on disposal of packaging materials and old
appliances.
On disassembly, additional dangers must be reckoned with,
which do not occur during operation.
Before disassembling the drive the system is to be mechan-
ically secured. The drive must not be forcibly disconnected
from the system.
WARNING
Risk of injury due to electric current.
Risk of electric shock.
►Separate power supply cables physically and discharge
any energy accumulators still charged. After switching off
the device, wait at least 5 minutes so that the motor can
cool down and the voltage can be discharged from the
capacitors.
►During disassembly work above head height, use suita-
ble, inspected and structurally stable climbing aids.
►Work on the electrics may only be performed by person-
nel described in the section "Safety notes on electrical
installation".
Removal for scrap
The international, national and regional laws and regula-
tions prevailing at the time of scrapping the product must be
observed.
Ensure that materials and components are recycled, dis-
mantled and separated properly in addition to observing the
environmental and health hazards relating to recycling and
disposal.
CAUTION
Environmental damage in case of incorrect disposal
►Electrical scrap and electronic components must be
handled as special waste and may only be disposed of by
approved specialist companies.
►Groups of materials such as various types of plastics and
metals must be separated before recycling/disposal.
Disposal of electrical and electronic components
The disposal and recycling of electrical and electronic com-
ponents must be carried out in accordance with the relevant
laws and national regulations.
12 Comments on EU Declaration of
Conformity
elero GmbH hereby declares that the RolMotion/D+ M tu-
bular drive is in compliance with all applicable regulations of
Machinery Directive 2006/42/EC and the Directive 2014/53/
EU. The full text of the EU Declaration of Conformity is
available at the following Internet address:
www.elero.com/downloads-service/
13 Energy efficiency
The drive remains below the legally required consumption
values of the European Ecodesign Directive 2023/826.
After the main function 'raising' or 'lowering' (active mode)
has ended and the roller shutter switch is left in the UP or
DOWN position, the power consumption is less than 0.3 W
(standby mode). There is no power consumption when the
switch is in the 'OFF' position.
14

Technical data and dimensions

The technical data specified is subject to tolerance factors
(according to applicable standards) and refer to an ambient
temperature of 20 °C.
© elero GmbH EN | 7