Dell PowerEdge 1750 Handbuch Seite 6

Locate the ROMB card connector on the system board. See Figure 1-2.
6
If a PCI card is installed over the ROMB card connector, remove it. See your
7
Installation and Troubleshooting Guide for instructions.
Position the ROMB card with the notch in its plastic cover facing the redundant power
8
supply bay, and align the edges of the card with the four plastic standoffs on the
system board. See Figure 1-2.
Press down on the ROMB card cover until the four plastic standoffs snap over the edge
9
of the card. See Figure 1-2.
F i g u r e 1 - 2 .
backup battery
1-2
I n s t a l l i n g a R O M B C a r d
I n s t a l l i n g t h e R O M B C a r d a n d B a c k u p B a t t e r y
ROMB card
plastic standoffs (4)
standoffs (2)
notch
RAID_BAT connector
ROMB card connector