Dell PowerEdge 1750 Handbuch Seite 5

This document contains information about installing a RAID on mother board (ROMB)
card.
Installing a ROMB Card
CAUTION: Only trained service technicians are authorized to remove the system
cover and access any of the components inside the system. See your System
Information Guide for complete information about safety precautions, working
inside the computer, and protecting against electrostatic discharge.
NOTICE: To avoid possible data loss, back up all data on the hard drives before changing the
mode of operation of the integrated SCSI controller from SCSI to RAID.
Remove the front bezel (if applicable).
1
Turn off the system, including any attached peripherals, and disconnect the system
2
from the electrical outlet.
Remove the optional security screw (if applicable). See Figure 1-1.
3
Press the latch on the system front panel and lift the left cover.
4
Lift the right cover.
5
F i g u r e 1 - 1 . O p e n i n g t h e S y s t e m C o v e r s
optional security screw
latch
left cover
right cover
I n s t a l l i n g a R O M B C a r d
1-1