ACD R4 ALULINE Bedienungsanleitung Seite 28

Page 23 Anchors
Put the greenhouse level again accounting for the desired slope (stimulate water drainage). Support the entire greenhouse with ground until it is
completely closed. For the anchors, dig a hole at the inside of the greenhouse, in each of the corners.
Install the anchors with the stop bolts and fill the holes with concrete.
ATTENTION: Greenhouses of 7 or 8 windows long also have a centre anchor.
Page 26 Window-raiser
This is an option.
Make sure that the hole in the cylinder axis corresponds to the first hole in the tube.
Push the smallest pin with its straight rod through the holes. Make sure that the pin sticks through the tube.
Turn the cylinder completely in the round nut.
First disassemble the roof window; then, disassemble the crossbeam.
Slide 2 stop bolts in the bolt slot of the crossbeam.
Reinstall the crossbeam. Make sure that the crossbeam is pressed completely against the glass. Then reinstall the rubber on the
crossbeam and have it fit closely to the side that is cut off diagonally.
The numbers of the detailed views indicate the assembly order. Tighten the assembly definitively.
Install the base plate firmly on the crossbeam with the two pre-mounted bolts.
Reinstall the roof window in its place and centre it.
Clamp the window-raiser base plate on the roof window tongue, using 2 bolts and a stainless steel plate.
Turning the cylinder determines the opening distance of the roof window at a specific temperature.
Q