Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3
ATTENTION!
Check the oil level before each start-up!
3.2 First use
READ THE MANUAL OF THE PNEUMATIC TOOL BEFORE CON-
NECTING IT TO THE COMPRESSOR!
Make sure the on/off switch
connect the compressor to an earthed socket protect-
ed by a residual current circuit breaker.
3.2.1 Switching on/off
Press the on/off switch
switched on.
To switch off the compressor, press the on/off switch
downwards.
2
3.2.2 Air pressure presets
The following pressures are preset:
- Switch-on pressure: approx. 8 bar
- Cut-off pressure: approx. 10 bar
3.2.3 Setting the air pressure
With the pressure regulator
(0 -10 bar). Pay attention to the nameplate of the pneumatic tool
to be connected!
12
GB/IE/NI/CY/MT
Now insert the oil sealing plug
firmly into the oil filler open-
3
ing.
is pressed down. Now
2
upwards. The compressor is
2
you can set the desired pressure
13
EXAMPLE: Type plate of an air tool
You can read off the actual pressure delivered on the pressure
gauge
. This is delivered at the quick coupling
15
The actual air pressure in the vessel 5 is displayed on the
pressure gauge
. This is delivered to the quick coupling
10
3.2.4 Safety valve
The safety valve
now audibly releases air. Then retighten the
11
drain nut clockwise .
NOTE
Repeat this process every 30 operating hours or at least three
times a year.
3.2.5 Draining condensation
Condensation collects at the bottom of the pressure vessel 5 .
Place a container under the drain plug 8 to catch any conden-
sation.
Open the drain plug 8 on the underside of the vessel
completely .
Wait until the condensation water has completely drained off.
Then close the drain plug 8 again.
CAUTION
Condensation must only be drained when the pressure vessel 5 is
NOT under pressure.
NOTE
Drain condensation after each operation, but at least once a week.
3.2.6 Releasing excess pressure (adjusting pressure)
Switch off the compressor.
Use the excess pressure with an idle pneumatic tool.
WARNING!
.
14
The safety valve
is set to the
11
maximum permissible pressure
of the pressure vessel 5 . It is
not permitted to adjust the
safety valve
or remove the
11
connection lock between the
drain nut and its cap.
Turn the drain nut counter-
clockwise to open the safe-
ty valve
outlet.
11
8
.
12
Werbung
