Maintenance; To Clean The Product; To Replace The Blades Of The Product; To Replace The Battery - Meec Tools Rmv500M20V Bedienungsanleitung

● Clean the product and the accessories before you
store them, refer to"7.1 To clean the product" on page
25.
● Examine the product and the accessories, if necessary
do the service and repair before you store them.
● Put the product in a clean and dry place, where
children and pets do not have access.
● Put the product in a dry area, protected from direct
sunlight and wet conditions.
● Stop the product by the power switch when the
product is not in use or put into winter storage.
● To prolong the battery life, charge the battery every 3
months if the product is not in use for a long period of
time.
7

Maintenance

Warning! Stop the product and let all moving parts
come to a complete stop before you do maintenance to
the product.
● Examine the product regularly to make sure that all
nuts, bolts and screws are tightened.
● Examine the product regularly to make sure that the
blades, blade bolts and cutter assembly are not worn
or damaged. If necessary, replace worn and damaged
parts.
Note! If the blades or bolts are worn or damaged, the
complete set must be replaced to make sure the product
is balanced.
● Make sure that the blade disc rotates smoothly and
that the blades can rotate without any restrictions.
● Examine and clean the charging station from any
debris or mud. Make sure that all connecting parts of
the charging station, extension cable, and power
supply are not damaged.
7.1

To clean the product

Caution! Do not use high pressure washer. Water
can leak into the sealings and damage the electronic and
mechanical parts of the product.
● Keep the product and its wheels clean to get the best
mowing results.
● Use a gentle brush or cloth to clean the external
surfaces.
● Do not use corrosive solvents for example alcohol,
gasoline, or acetone. These substances can cause
damage to the components of the product.
● To clean the chassis and blade disc, use a brush or a
water hose.
● Do a check of the rain sensor once a month and make
sure that it is not covered by mud, grass or other
objects. Clean with water and a soft brush if
necessary.
Note! Dry the sensor area after cleaning so that does not
get activated as it would be by rain.
● Clean the camera regularly.
● Use a brush to clean the drive wheels (rear wheels) to
make sure that the tires have a good grip.
7.2 To replace the blades of the
product
Warning! Make sure that all moving parts come
to a complete stop before you replace the blades of the
product.
Warning! Screws that are damaged, worn, or
cannot be tightened correctly must be replaced.
Warning! The blades are sharp. Wear protective
gloves to prevent injuries.
● The blades have a service life of up to 2 months if the
product operates daily.
● After the new blades are installed, make sure that the
blade disc can move freely.
1
Turn the product upside-down. (Figure 17)
2
Remove the screws and the blade with a
screwdriver.
3
Attach new blades and screws. Make sure that the
screws a fully tightened.
Note! The recommended torque is: 1.0+0.2 Nm. Make
sure the blades can rotate freely.

7.3 To replace the battery

Warning! Make sure that all moving parts come
to a complete stop before you replace the battery of the
product.
Warning! The battery pack contains electrolytes.
If the electrolyte leakage comes into contact with your
skin, wash off with soap and water immediately. In case
of eye contact immediately flush the eyes with plenty
of water for at least 15 minutes without rubbing and get
medical help.
EN
SV
NO
PL
DE
FI
FR
NL
25