To Do Before You Operate The Product; To Operate The Product; To Identify The Zone - Meec Tools Rmv500M20V Bedienungsanleitung

4.2 To do before you operate the
product
Warning! Make sure that there are no children or
pets in the area.
Warning! Push the "STOP" button to stop the prod-
uct before it is moved from or in the mowing area.
Caution! Make sure that the area have a clearly
defined limit line where the lawn ends.
● Examine the mowing area regularly and remove
stones, wires and other foreign objects.
● Make sure that the grass in the lawn is not higher than
10 cm.

4.3 To operate the product

Warning! Set the product to "LOCK" before you
clear blockages or before you examine, clean or do
maintenance.
Warning! All the blades of the product can move
when one of the blades is turned. Risk of personal injury.
4.3.1 Parts of the product and basic control
● Rotary Button: The button is used to manually adjust
the cutting height of the blades.
● Wide-angle Camera: Identifies boundaries and
multi-zones, detects and prevent collision to obstacles.
● Collision Bumper: If the visual positioning fails the
collision bumper will make sure that the product
continue to function correctly. Bumper sensors are
installed inside the product to detect obstacles. When
the bumper bumps into an obstacle and triggers the
sensor, the product will go backward and avoid the
obstacle.
● Rain Sensor: The rain sensor can detect rain and
control the product to automatically return to the
charging station to prevent precipitation refered to the
registered settings.
● To start the product: Push and hold the switch button
for 2 second.
● To stop the product: Push and hold the switch button
for 3 seconds. The display will show the word "bye"
and then turn off.
● To start the operation: Push the "START" button and
then the OK button.
● To send the product back to the charging station:
Push the "HOME" button and then "OK" button.
4.3.2 To restart the product
1
Stop the product, push the switch button for 3
seconds.
2
Restart the product or put it back to the charging
station to charge and then start it again.
Note! If the product is in lock status you must enter the
PIN-code before you can operate the product manually.
(Figure 12)
Note! The product will automatically stop if there is no
input in 30 seconds after the power button is pushed.
3
Push the "START" button and then the "OK" button.
The product operation starts.
Note! The product operation continues until the battery
level is low. The product will then go to the charging sta-
tion. The product operation starts again when the battery
is fully charged or at the next scheduled start time.
4
To stop the operation and send the product to the
charging station, push the "HOME" button and
then the "OK" button.
4.3.3 The charging station
The product goes back to the charging station when:
● The power of the battery is low.
● The operation in the working area is finished.
● It rains.
● It is dark outside.

4.4 To identify the zone

During the initial start up the product must identify the
working area.
4.4.1 Single zone
Note! The instruction below is only applicable for a single
zone area.
● Make sure that the product is in the charging station.
1
Start the product and enter the PIN-code.
2
Push "START" and then the "OK" button. The
product will automatically exit the charging station
and search for the limit lines of the lawn.
EN
SV
NO
PL
DE
FI
FR
NL
23