Bresser Tendence FSX Bedienungsanleitung Seite 9

7 Transmission symbol (ra-
dio-controlled clock CET)
9 Air pressure (mb/hPa or
inHg)
11 Bar chart for air pressure
history
13 Humidity outdoors
15 Battery status
17 Temperature (outdoor)
19 Sensor signal status
21 Weather trend (24 hours)
6 Setting up power supply
Base unit
1. Remove the battery compartment cover.
2. Insert batteries into the battery compartment. Make
sure that the batteries are correctly aligned (+/- poles).
3. Replace the battery compartment cover.
4. Wait until indoor temperature is displayed on the base
unit.
Wireless sensor
5. Remove the battery compartment cover.
6. Move the CH slider to the position for the desired trans-
mission channel (setting CH1, CH2 or CH3 with indica-
tion on the display).
7. Insert batteries into the battery compartment. Make
sure that the batteries are correctly aligned (+/- poles).
8. Replace the battery compartment cover.
9. Press the SET button for approx. 2 seconds.
NOTICE! When operating only one wireless sensor, channel
1 is recommended as the default setting.
8 Alarm (AL1 or AL2)
10 Moon phase
12 Weather trend (72 hours)
14 Humidity indoors
16 Temperature (indoor)
18 Channel info (sensors)
20 Weather trend (48 hours)
22 Singles values for air pres-
sure history (up to 24
hours)
9 / 108