7 Connecting remote sensors
The Weather Station can display the readings from up to 3
wireless sensors* of the same type. Each radio sensor must
be set to a separate channel. Proceed as follows to set the
channel:
1.
2.
3.
4.
5.
• one wireless sensor included, others optionally available
8 Battery level indicator
1.
2.
10 / 108
Remove the battery compartment cover of the wireless
sensor.
Set the channel selection switch to the desired channel
(CH1, CH2 or CH3).
Re-attach the battery compartment cover.
NOTICE! Each connected wireless sensor must be set to
a different channel. If only one wireless sensor is con-
nected, it should be set to CH1.
Press the CH/UP button on the base station several
times to display the measured values for the individual
channels. The selected channel is shown in the display.
When the level of the batteries in the base station or in
the wireless sensor reaches a critical level, the battery
level symbol appears in the appropriate area on the
display.
When replacing one set of batteries, always remove the
batteries from the other part of the unit and reinsert
them in the correct order (see chapter "Setting up
power supply"). Replace the batteries to be changed in
the corresponding part of the device with a completely
new set with full capacity. This ensures that the connec-
tion between the devices will be reestablished again
correctly.