Bresser Tendence FSX Bedienungsanleitung Seite 11

9 Automatic time setting
After the power supply was established, the clock will auto-
matically search for the radio signal. This will take approx-
imately 3 to 8 minutes to finish this process.
If the radio signal is received correctly, the date and time
will be set automatically and the radio control signal icon
turns on.
If the clock fails to receive the time signal, go ahead with the
following steps:
1. Press °C/°F button on the base station for approx. 3
seconds to initate RC signal reception again.
2. If the device is still not receiving the signal, the time
must be set manually.
10 Manual time setting and other user defined
settings
1. Press the SNOOZE/LIGHT button for about 8 seconds to
deactivate the automatic time setting. The reception
symbol for the radio-controlled watch disappears from
the display.
2. In normal display mode, press the TIME button for
about 2 seconds to enter the settings mode.
3. Digits to be set are flashing.
4. Press CH/UP or 12/24/DOWN button to change the
value.
5. Press the TIME button to confirm and switch to the next
setting.
6. Sequence of the settings: Year > Change day/month
display > Month > Day > Daylight saving time (DST)
AUTO/OFF (off) > Hours > Minutes > Seconds > Lan-
guage > Time zone (-23 to +23 hours)
7. Finally press the TIME button to save the settings and
exit the settings mode.
11 / 108