8.
11 Alarm settings
1.
2.
3.
4.
5.
6.
NOTICE! If ice alert is enabled (on), the alarm will sound 30
minutes before the set alarm time if the temperature is -3°
or below.
7.
8.
12 Snooze function
1.
2.
12 / 108
NOTICE! To restore the automatic time setting, press
the SNOOZE/LIGHT button again for 8 seconds. The re-
ception symbol for the radio-controlled watch re-
appears in the display.
In normal display mode, press the TIME button several
times to display the Alarm time AL1 or AL2.
Press ALARM button for approx. 3 seconds to enter the
alarm time setting mode.
Digits to be set are flashing.
Press CH/UP or 12/24/DOWN button to change the
value.
Press ALARM button to confirm and continue to the
next setting.
Settings order: hours > minutes > ice alert on/off
Finally press the ALARM button to save the settings and
exit the setting mode. Alarm will be activated automat-
ically. The
symbol will be displayed.
In normal display mode, press the ALARM button sev-
eral times to enable alarm time AL1, AL2 or both. If the
alarm is enabled, the corresponding symbol will be dis-
played ( 1,
2 or
When the alarm sounds press the SNOOZE/LIGHT but-
ton to activate the snooze function. The alarm will
sound again in 5 minutes.
Press ALARM button when the alarm sounds to inter-
rupt the alarm until the alarm time will be reached
again.
1 2).