Safety Instructions; Overview - Traxon E:cue Rdm Isolator Bedienungsanleitung

RDM Isolator — Information for Use
1

Safety instructions

Only use the device in compliance with the environmental
conditions specified and watch the technical
i
characteristics. Otherwise the unit may be damaged or
malfunction will happen.
Only use original e:cue accessories to power the RDM
i
Isolator Other power supplies can damage the unit.
To prevent the device from overheating, only operate
it in well-ventilated environment. Ventilation may not be
i
obstructed. Do not install next to heat emitting sources or
in a place subject to direct sunlight.
Device components inside the system can reach high
temperatures! To avoid burns, allow the unit to cool for at
least 20 minutes before unmount or repair.
Installation and maintenance of this product must be
performed by individuals who are knowledgeable about the
i
procedures, precautions and hazards associated with the
product.
2

Overview

The RDM isolator repeats DMX and e:pix (one way) as well as RDM (bi-
directional) signals over a galvanic isolation barrier. The power supply
has a separate isolation barrier ("external" selected) or is aligned with
the output potential ("DMX power" selected). In some cases DMX
cable electrically connect installations with different power sources
(with slightly different electrical potential) this may result in unwanted
links causing ground loops or earth loops. Also, long cable runs cause
signal attenuation. A signal amplification is required every 32 DMX
fixtures or a cable length of more than 300 meters for DMX, for e:pix
| Safety instructions
4 / 16