Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GeneRal safeTy InfORmaTIOn
1.
1.1
General safety information
Safety rules for operating the floor stripper / scraper
Information
The floor stripper / scraper is constructed according to existing safety rules and regulati-
ons. These technical precautions should not be removed or changed under any circum-
stances.
Ensure that any user of the machine is fully familiar with the instructions for use before allo-
wing work to start. While operating the machine the following points should also be kept in
mind:
Danger!
• The floor stripper should always be operated with all safety covers and technical precautions.
• During transport, cleaning, repair or maintenance the floor stripper must be disconnected from
the mains. This also applies to the changing of tools.
• Always remove the tool before transporting the machine.
• Only tools supplied or approved by CONTEC / TYROLIT may be used.
• The machine operator should never leave the machine unattended during operation.
• Before leaving the machine all rotary parts should be brought to a standstill. The floor stripper
must be disconnected from the mains. Make sure that the machine cannot roll or move by itself.
• The floor stripper should be switched off immediately if unusual noises or vibrations are detected
during the operating of the machinery. A thorough check must be carried out in order to detect
the cause.
• After any maintenance and adjustment all safety covers must be reattached.
• Protection equipment for both eyes and ears must be worn by the machinist.
• The machinist must wear safety shoes with steel toecaps.
ATTENTION!
Depending on the type of floor (floor coating) stripping can produce gases/dust. The ope-
rator must be held responsible if these generated gases/dust are dangerous and if pro-
tection is necessary. Stripping floors containing asbestos is especially dangerous and can
cause health problems. Special masks must be worn which keep the breathing air clean. A
dust collector must be used and should be equipped with filters suitable for asbestos dust.
The floor must be swept before stripping. Anchor screws and bolts coming out of the floor
can be better seen if the floor is clean. If the stripping tool strikes an anchor screw or bolt
then serious damage can be caused to the machine or tools.
5
Werbung
