Contec MULE Betriebsanleitung Seite 21

TROUble shOOTInG
2.8
3.
After Use
Attention! Motor and switch are not splash-proof.
f Clean the machine thoroughly.
f If using a water hose or high-pressure cleaner, do not direct the water jet at the electri-
cal components.
f All components must be checked daily for tightness.
CHECKLIST:
This checklist should be checked every 8 to 10 hours.
PULL OUT THE MAINS PLUG!
9 Check the condition of the knife.
9 Check that all screws and nuts are tight.
9 Grease the linear bearings monthly using the grease nipples.
9 Check all electrical cables and plugs.
Trouble Shooting
Problem
Machine does not
run
Poor performance
Excessive
vibration
Mögliche Ursache
– Power supply
disconnected
– Blown fuse
– Defect cable
– Blade is blunt
– Machine parts are worn
out
Beseitigung
– Check power supply.
– Have machine repaired by a
qualified electrician,
– Check and change parts
– Change blade
– Return machine for repair or
service
9