Rinsing; Making Several Cups Of Coffee With The Jug Function - AEG Electrolux CG 6600 Gebrauchsanweisung

g
water run into the cup (and then
empty it).
• Do not use cups that are too thick,
unless they are preheated, as they
absorb too much heat.
• Use preheated cups by rinsing them
out with warm water or leaving
them at least 20 minutes on the
heated cup tray (H) when the coffee
machine is switched on.
7.2

Rinsing

Rinsing allows the brewing unit and
the coffee dispenser to heat up.
Rinsing only take a few seconds.
0 Press the "MENU" button (Figure 5).
The menu option «CHOOSE LAN-
GUAGE» appears.
0 Press the scrolling buttons "<" or ">"
(Figure 6) until the menu option
«RINSING» appears.
0 Confirm the menu option with the
"OK" button (Figure 6). The display
shows «RINSING» and a progress bar
shown with a percentage
«
After rinsing the appliance automati-
cally returns to coffee mode.
8 Making several cups of
coffee with the jug
function
Using this function you can
makeseveral cups of coffee fully
automatically in thestainless steel jug
supplied: Milling, portioning, pressing,
pre-brewing, brewing and disposing
the brewed coffee grounds as
described in the preceeding section.
The appliance is preset to a medium
cup size and normal coffee strength.
You can set your preferred cup size and
coffee strength as „Setting the jug pro-
gramme (Coffee strength and filling
quantity for the jug)" page 51
described underneath.
46
0 Turn the lid on the stainless steel jug
0 Put the lid in the pouring position (Fig-
0 Make sure that the water tank is full,
40%».
3
0 If necessary, set the number of cups
3
0 When you have selected the desired
supplied to the removal position (Fig-
ure 17) and remove the lid. Rinse the
jug and the lid.
ure 18) on the jug and place this
underneath the coffee dispenser (D).
The coffee dispenser must be pushed
right to the tip so that the jug can be
pushed into position.
The display continusously shows «FILL
BEAN CONT. AND WATER
TANK, EMPTY WASTE CONT.,
PRESS OK», reminding you of the
basic steps necessary to be able to
make a series of coffees in the jug.
that there are enough coffee beans in
the bean container and that the waste
coffee container is empty. Then press
the "OK" button (Figure 6).
The display shows the coffee strength
on the top line, as it is set in the "jug"
menu, e.g. «EXTRA-MILD JUG». The
scrolling buttons "<" or ">" appear on
the bottom line, as does the number of
cups to be made in the jug, e.g.
> 4».
«<
If you want to change the coffee
strength and the filling quantity for
the jug function, proceed as described
below „Setting the jug programme
(Coffee strength and filling quantity
for the jug)" page 51.
that are to be made in the jug (4, 6, 8,
10 cups) with the scrolling buttons "<"
or ">" in steps of 2 cups.
If no button is pressed for a few sec-
onds, the appliance suggests the next
step in the display: «CHOOSE NUM-
BER OF COFFEE, PRESS JUG
KEY».
number of cups, confirm this by press-
ing the "jug/cappuccino" button
(Figure 19).