Tips For Dispensing Hotter Coffee - AEG Electrolux CG 6600 Gebrauchsanweisung

If no button is pressed for a few sec-
3
onds after setting the cup size or cof-
fee strength, the appliance suggests
the next step on its display: «PRESS
1 OR 2 CUPS KEY».
0 Press the "1 cup of coffee" button to
make one cup, or the "2 cups" button
for 2 cups.
The appliance now mills the beans. In
the coffee making process, the ground
coffee is firstly sprinkled with a small
amount of water for pre-brewing pur-
poses. After a short interval the actual
brewing process takes place. The coffee
is dispensed into the cup, the top line
of the display shows the selected cup
size and the bottom line a progress bar
with a percentage
«
When the progress bar is completed,
the desired amount of coffee is dis-
pensed. The appliance finishes dispens-
ing automatically and ejects the used
coffee grounds into the waste coffee
container.
0 You can stop the coffee from dispen-
sing at any time by pressing the pre-
viously selected"1 cup"
button again, or by turning the
"cup size" knob (Figure 13) anti-clock-
wise towards "espresso cup".
0 As soon as the coffee has finished dis-
pensing, you can increase the amount
of coffee by pressing and holding the
"1 cup" button
amount of coffee is reached (the but-
ton must be pressed as soon as the
progress bar reaches 100 %), or by
turning the"cup size" knob (Figure 13)
clockwise towards "mug".
After a few seconds the appliance is
ready to be used again and you can
make another coffee. The display
shows the last selected coffee setting.
3 If the coffee only comes out in drips or
not at all, or if the coffee comes out
too fast and the crema is not to your
taste, you should change the grind
level setting, see „Setting the grind
level" page 50
40%».
or "2 cups"
until the desired
When the display shows the message
3
«FILL TANK !», you must fill the
tank, otherwise the appliance cannot
make any coffee. (It is normal for there
to be some water left in the water tank
when the message is displayed).
When the display shows the message
3
«EMPTY WASTE COFFEE CON-
TAINER», it means that the waste
coffee container is full and must be
emptied and cleaned, see „Emptying
the waste coffee container" page 56.
As long as the waste coffee container
is not cleaned, this message remains in
place and the coffee machine cannot
make any coffee.
Never take the water tank out whilst
3
coffee is being dispensed. If it is taken
out, the coffee machine can no longer
make any coffee. To bleed air from the
coffee machine, please press the "hot
water" button and let water run out
of the hot water nozzle for a few sec-
onds.
When installing the coffee machine for
3
the first time you should make at least
4-5 coffees before the machine can
give a satisfactory result.
7.1

Tips for dispensing hotter coffee

• If you want to make enough coffee
for a small cup (less than 60 ml)
immediately after switching on the
coffee machine, use the hot water
from the rinsing procedure to
preheat the cups.
• Set a higher coffee temperature in
the appropriate menu, see „Setting
the coffee temperature" page 50.
• If you have not dispensed any coffee
for a long time with the appliance
switched on, you should first rinse
the system to preheat the brewing
unit. Select the rinsing function
from the appropriate menu (see
„Rinsing" page 46). Let the water run
into the drip tray underneath. You
can also use this water to warm up
the cup that you are using for the
coffee. In this case simply let the hot
g
45