Werbung
Security Statment and warning
Before operating the Laser Engraver, please read the manual carefully and follow the instructions for assembly and operation.
If this manual does not effectively solve your problem, please contact our support team.
1. This product is a laser engraver system .Components, must be installed in other manufacturers of laser engraver for use. The product
belongs to Class 4 laser products. The laser system itself must meet the requirements of IEC 60825-1 latest version, otherwise the
product is prohibited to be used.
2. Your laser engraver shall have a protective housing which, when in place, prevents human access to laser radiation.
3. If a protective housing is equipped with an access panel which provides "walk-in" access then:
a) means shall be provided so that any person inside the protective housing can prevent activation of a laser hazard that is equivalent
b）a warning device shall be situated so as to provide adequate warning of emission of laser radiation equivalent to Class 3R in the
wavelength range below 400 nm and above 700 nm, or of laser radiation equivalent to Class 3B or Class 4 to any person who might
be within the protective housing.
c) where "walk-in" access during operation is intended or reasonably foreseeable, emission of laser radiation that is equivalent to Class
3B or Class 4 while someone is present inside the protective housing of a Class 1, Class 2, or Class 3R product shall be prevented by
engineering means.
NOTE: Methods to prevent human access to radiation when persons are inside the protective housing can include pressure
sensitive floor mats, infrared detectors, etc.
02
Werbung
