Herunterladen Diese Seite drucken

Create Potts Bedienungsanleitung Seite 8

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 51
This instruction manual cannot cover all possible circumstances. In case of doubts or
problems not adequately described in this operating manual, you can obtain more information
by contacting the Customer Service Department. Please keep this instruction manual for
reference if necessary.
1. Remove your coffee machine from its packaging.
2. After unpacking, verify that the following parts are included:
· Water tank
· Coffee maker
· Manual
· Capsule and ground coffee adapters.
Note:
• Verify that the voltage of the electrical current in your home or establishment is the same
as that stated on the nameplate of the machine.
• Recycle all plastic bags to avoid hazards to children!
• Keep the packaging for transporting the machine (e.g. for disassembly, repair, etc.).
Before using your coffee maker for the first time, pay attention to the safety precautions in
this manual, in particular the following:
• Be careful with the hot water! You could get burnt.
• Rinse the water tank thoroughly with clean water before the first use.
• Do not operate the unit with an empty water tank or if the water level is below the minimum level.
• Only use the appliance in a dry room.
• Do not open the lever when the machine is warming up or running.
• Always unplug the power cord before cleaning the machine.
• Clean the coffee maker only with a damp cloth.
The first step is to fill the water tank; there are two ways to do
this:
Fill without removing the tank.
1. Lift the water tank cover.
2. Fill the tank with clean water (maximum water temperature:
35°C).
3. Lower the tank cover.
Fill by removing the water tank.
1. Slightly lift the water tank in the direction shown in the
picture to remove the water tank from the appliance. Fill
the tank to the "MAX" line with clean water (maximum ca-
pacity: 0.6 litres).
2. Slowly slide the water tank over the base of the water
tank, performing the reverse procedure described above.
When the water tank outlet is inserted into the inlet base,
push down to lock the water tank.
• Warning:
There may be a drop of water left in the appliance. To ensure that this unit works perfectly, it
was tested with water before it left the factory.
• Caution:
Improper handling of electrical equipment is dangerous and can be lethal.
E NGL I SH
8
ABOUT THIS MANUAL
UNPACKING
GETTING STARTED

Werbung

loading