Create Potts Bedienungsanleitung Seite 12

4. The LEDs on the buttons will stabilize when the machine has warmed
up. The warm-up time is approximately 45 seconds.
Before pressing the long coffee button, make sure that:
• The compartment lever is closed and there are no capsules inside.
• The water tank is full.
• The water tank is firmly in place, otherwise the water may leak.
5. Place a large cup (size 250ml or larg-
er) under the dispenser.
7. Do not lift the lever until the rinsing process stops automatically.
• If there is no water flow in the coffee machine, it will be necessary to drain the internal
water pump.
• This procedure may be necessary if the coffee maker is left unused for a long time time
or if it was activated without water in the tank.
• It is advisable to drian your coffee machine when you are going to use it for the first
time.
• To drain the pump and use the coffee maker normally follow the following steps:
1
1. Unplug the appliance and remove the water tank. Remove the capsules and capsule
holders from the coffee maker and leave the drill lever down. Connect the plastic pump
to the water inlet and remove the plunger.
2. Add some water to the pump.
3. Attach the plunger to the pump and push it to the end.
• The water contained in the pump will pass to the internal system, causing the air con-
tained in the ducts to be eliminated.
• During this process, a little water may escape from the pin located on the upper back of
the appliance, use a cloth so that the water does not drain on the table.
• If necessary, repeat this procedure 2 or 3 times.
E NGL I SH
12
DRAINING YOUR COFFEE MACHINE
6. Press the long coffee button and wait
for the appliance to complete the
rinse.
2 3