Refco TRITECTOR Bedienungsanleitung Seite 12

Automatic reset
After 30 seconds, the leak detector resets itself. This function takes
into account the changes in the environment and resets itself just if
there are no significant changes. By default, this function activated,
but you have the possibility to turn this function off. By pressing
& simultaneously for three seconds this function is
disabled.
By disabling this function, the
When starting the TRITECTOR, it will reset itself for the first time
(Ambient concentration reset).
Manual reset
The manual reset allows you to reset the TRITECTOR whenever you
want, and you feel that it is necessary.
To manually reset the TRITECTOR, press briefly
sounds and all rings on the display light up briefly, to indicate that
the manual reset has been performed.
Peak
The Peak function facilitates searching for a leak in a hard to reach
area without being able to see the LCD display.
The Peak function shows the highest concentration detected by the
TRITECTOR. To enable the peak function, press and hold the peak
button for 3 seconds. As long as the function is enabled, the
icon appears in the display.
To disable the function press and hold the peak button again.
12
symbol appears in the display.
Instruction Manual
. A double tone