Shark RIDILL 2 Benutzerhandbuch Seite 46

REMOVING THE CHEEK PADS
3 - Turn the helmet over again to more
easily undo two front snap fasteners, one
side velcro fastener and one rear snap
fastener on each cheek pad. Hold the two
velcro surfaces on either side in place as
much as possible in order to gently loosen
the area (A).
4 - Completely remove each of the cheek
pads from the inside by sliding them onto
each end of the chinstrap while turning
the helmet over if necessary.
20
A
REMOVING THE COMFORT LINER
3
4
1 & 2 - Slide your hand underneath the
back of the comfort liner and pull it
towards you on both sides to release the
comfort liner from its two clip fasteners.
1
2