Fritz! Smart Control 350 Installation Und Betrieb Seite 21

Register
1. Insert the batteries in the top shell of
the sensor.
The LED will start to flash.
2. Press the Connect button on your
FRITZ!Box within 2 minutes.
or
Within 2 minutes, press the DECT
button on your FRITZ!Box
for 6 seconds.
3. The sensor LED lights up for 10 sec-
onds and FRITZ!Smart Control 350 is
registered.
4. Close FRITZ!Smart Control 350.
Push lightly to connect the top shell of the
sensor with the lower shell.
If FRITZ!Smart Control 350 was not
registered, remove the batteries for
1 minute and repeat the registration
process.
21