VEVOR M1B-LS-3301 Benutzerhandbuch Seite 5

12. Secure the workpiece. Secure the workpiece with stand. This is safer than using
your hands and means you have both hands free to operate the tool.
13. Do not overreach. Always maintain a firm footing and good balance.
14. Maintain the tool in good care. Keep cutting tools sharp an chean for better,
safer work. Follow the instructions for lubricating and for the replacement accesso-
ries. Check power cords regularly. If damaged, they must be replaced at an autho-
rised service centre. Check extension cords at regular intervals and replace them if
they are damaged. Keep the hands clean、dry and free from oil and grease.
15. Always unplug the power cord. when the tool is not being used, and before
carrying out service work or changing accessories, such as knife blades/carbon
brush/gears and so on.
16. Remove adjuster keys/spanners and other assembling tools. Remove adjuster
keys/spanners and other assembling tools before starting the power tool.
17. Avoid accidental starting. Never carry a power tool with your finger on the
switch when it is connected to the mains. Make sure the power switch is in the OFF
position before plugging in the power cord.
18. If using the tool outdoors. only use an extension cord approved for outdoor use.
19. Stay alert . Always be careful when using the equipment. Use your common
sense ,Do not use the tool if you are tired.
20. Connect dust extraction equipment . If dust extraction and dust collection
equipment is provided. This should be connected and used correctly.
21. Check for damaged parts. If a guard or some other part has been damaged,
check carefully before using the tool to ensure that it will operate correctly and as
intended. Make sure that moving parts are properly adjusted and do not jam and
that no parts are incorrectly fitted or damaged. Check for any other factors that
could influence functionality. Guards or other parts that are damaged must be
repaired or replaced by an authorised service centre. Unless otherwise specified in
these instructions. If the power switch does not work, it must be replaced by an
suthorised service centre. Do not use the tool if it cannot be switched on and off
using the power switch.
WARNING! The use of accessories or attachments other than those recommended in
these operating instructions can result in personal injury. Repairs must only be
carried out by qualified personnel. This power tool has been manufactured in
compliance with current safety standards and requirments. Repair may only be
carried out by qualified personnel using identical spare parts. Failure to carry out
repairs currectly can result in the risk of personal injury/death or material damage.
NOTE: A temporary voltage drop can occur when starting the machine. Which could
affect other equipment. If the main supply impedance Zmax. is lower than
0.206ohms, this kind of interference is common. Contact your electricity supplier for
more information.
03