Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Warning! Check that total 18 screws are tightened.Turn the blade holder by hand
to check that it rotates easily and smoothly. Handle the blades with caution to
avoid personal injury and/or damage to property.
LUBRICATION :
1. Regularly remove shavings from the depth setting chains、reduction drive and
lifting screws for the blade holder.
2. Remove chips with a cloth and brush and lightly grease with a clean brush dipped
in oil.
3. Never pour oil directly on the components-- too much oil means dust will stick
and impair lubrication, which in turn shortens component life.
4. The balde holder's bearings are sealed and must not be lubricated.
MAINTENANCE
1. Keep the machine clean and free of dust and chips.
2. Clean reapped materials from the blade holder and tongues and carefully lubri-
cate with a clean brush dipped in oil.
3. Remove resin and the like from the rollers and work table with a non-flammable
solvent.
4. Clean plastic parts with a damp cloth and mild detergent. Never immerse the tool
in water or any other liquid. Never use detergents or alcohol.
5. Always check that all guards and other components are correctly fitted before use.
Guards or other parts that are damaged must be repaired or replaced by an autho-
rised service centre, unless otherwise specified in these instructions.
15
Werbung
