Werbung
Verfügbare Sprachen
Verfügbare Sprachen
16
Trouble Shooting
Problem
Shotblaster ma-
chine works brief-
ly and then ejects
all abrasive (« car-
peting effect».
Possible cause
– Is the blast wheel ro-
taing in the correct di-
rection?
– Has the blast wheel
worn out?
– Has the shot cage been
correctly adjusted?
– Has the shot cage worn
out?
– Is the rubber seal
around the magnetic
frame lying snugly with
the floor?
– Is the rubber seal worn?
– Is the shot blaster set
too high?
– Is the turbine drive belt
too loose? (There is
slippage and the impel-
ler does not reach the
required speed)
– Can the floor be sand-
blasted? Is it dry, not
too elastic or too soft?
TROUble ShOOTInG
Solution
– Check the rotation.
– Change the blast wheel.
– Adjust the shot cage.
– Change the shot cage.
– Readjust teh rubber
sealings around the magne-
tic frames.
– Change the rubber seals.
– Readjust the height of the
machine.
– Tighten the belt.
– Check the condition of the
floor first and consider alter-
natives to shotblasting if the
floor is too soft.
Werbung
