Replacing The Lamp - ZANKER ZKK8412K Benutzerinformation

Problem
It is too cold inside the freez-
er
The appliance does not work
at all. The appliance does not
cool at all. Neither cooling
nor lighting works

Replacing the lamp

Caution! Disconnect the plug from the mains
socket.
1. Remove the screw
from the lamp cov-
er.
2. Remove the lamp
cover (refer to the
illustration).
3. Replace the used
lamp with a new
lamp of the same
Possible cause
Food placed in the appliance was
too warm
Products to be frozen are placed too
closely to each other
Temperature Regulator may be set
incorrectly
The appliance may be switched off
Plug is not connected to the mains
socket properly
Power does not reach the appliance
There is no voltage in the mains
socket (try to connect another appli-
ance into it)
Allow food to cool to room temperature
before storing.
Place the products in a way so that
cold air could circulate among them
Set a warmer temperature
Switch on the appliance
Connect the mains plug properly
Try connecting another electrical de-
vice to the power outlet
Call an electrician
power and specifically designed for household ap-
pliances (the maximum power is shown on the
lamp cover).
4. Install the lamp cover.
5. Tighten the screw to the lamp cover.
6. Connect the plug to the mains socket.
7. Open the door. Make sure that the light comes on.
Solution
21