Replacing The Lamp; Closing The Door - ZANKER KNLK14FS Benutzerinformation

Problem
Some specific surfaces inside the
fridge compartment are warmer at
some times.
Temperature setting LEDs flash at
the same time.
If the advice does not lead to the desired
result, call the nearest Authorized
Service Centre.

Replacing the lamp

The appliance is equipped with a longlife LED interior
light.
Only service is allowed to replace the lighting device.
Contact your Authorised Service Centre.
Possible cause
Many food products are stored at
the same time.
The thickness of the frost is greater
than 4-5 mm.
The door has been opened often.
The FastFreeze function is switched
on.
There is no cold air circulation in the
appliance.
An error has occurred in measuring
the temperature.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to installation
instructions.
3. If necessary, replace the defective door gaskets.
Contact the Authorised Service Centre.
Solution
Store less food products at the
same time.
Defrost the appliance.
Open the door only if necessary.
Refer to "FastFreeze function" sec-
tion.
Make sure that there is cold air cir-
culation in the appliance. Refer to
"Hints and Tips" chapter.
This is a normal state.
Contact the nearest Authorised
Service Centre. The cooling system
will continue to keep food products
cold, but temperature adjustment
will not be possible.
15