Replacing The Lamp - ZANKER KXAK82FR Benutzerinformation

Problem
Water flows on the rear plate of
the refrigerator.
There is too much condensed
water on the rear wall of the re‐
frigerator.
Water flows inside the refrigera‐
tor.
Water flows on the floor.
The temperature in the appliance
is too low/too high.
If the advice does not lead to the
desired result, call the nearest Authorized
Service Centre.

8.2 Replacing the lamp

The appliance is equipped with a
long-life LED interior light.
12 ENGLISH
Possible cause
During the automatic defrosting
process, frost melts on the rear
plate.
Door was opened too frequently.
Door was not closed completely.
Stored food was not wrapped.
Food products prevent the water
from flowing into the water collec‐
tor.
The water outlet is clogged.
The melting water outlet is not
connected to the evaporative tray
below the appliance.
The temperature is not set cor‐
rectly.
The door is not closed correctly.
The food products' temperature is
too high.
Many food products are stored at
the same time.
The door has been opened often.
There is no cold air circulation in
the appliance.
It is strongly recommended to use
original spare parts only.
Use LED bulbs (E14 base) only. The
maximum power is shown on the lamp
unit.
Solution
This is correct.
Open the door only when neces‐
sary.
Make sure the door is closed
completely.
Wrap food in suitable packaging
before storing it in the appliance.
Make sure that food products do
not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet to
the evaporative tray.
Set a higher/lower temperature.
Refer to "Closing the door" sec‐
tion.
Let the food products tempera‐
ture decrease to room tempera‐
ture before storage.
Store less food products at the
same time.
Open the door only if necessary.
Make sure that there is cold air
circulation in the appliance. Refer
to "Hints and Tips" chapter.