Replacing The Lamp - ZANKER KBB24001SK Benutzerinformation

Problem
There is too much frost and
ice
It is too warm in the freezer
It is too cold inside the freez-
er
The appliance does not work
at all. The appliance does not
cool at all. Neither cooling
nor lighting works

Replacing the lamp

Caution! Disconnect the plug from the mains
socket.
22
Possible cause
Products are not wrapped properly
Doors are not shut properly or do not
close tightly
The Temperature Regulator may be
set incorrectly
Temperature Regulator may be set
incorrectly
The door does not close tightly or it
is not shut properly
Large quantities of food to be frozen
were put in at the same time
Food placed in the appliance was
too warm
Products to be frozen are placed too
closely to each other
Temperature Regulator may be set
incorrectly
The appliance may be switched off
Plug is not connected to the mains
socket properly
Power does not reach the appliance
There is no voltage in the mains
socket (try to connect another appli-
ance into it)
Wrap the products better
Check if the doors close well and the
gaskets are undamaged and clean
Set a warmer temperature
Set a lower temperature
Check if the door closes well and the
gasket is undamaged and clean
Insert smaller quantities of food to be
frozen at any one time.
Allow food to cool to room temperature
before storing.
Place the products in a way so that
cold air could circulate among them
Set a warmer temperature
Switch on the appliance
Connect the mains plug properly
Try connecting another electrical de-
vice to the power outlet
Call an electrician
1. Remove the
screw from the
lamp cover.
2. Remove the
lamp cover (refer
to the illustra-
tion).
3. Replace the
used lamp with a
new lamp of the same power and specifically de-
signed for household appliances (the maximum
power is shown on the lamp cover).
Solution