simu T5 AUTOBHZ Originalanleitung Seite 7

4.3 - Programming the first individual control point
This operation can only be performed from the
transmitter that was used for operation 4.1.
- Press the transmitter "PROG" Key for approximately one
second. The motor will run for 0.5 second in one direction and
then in the other.
Your transmitter is now programmed to control the motor in stable
mode. Move to the stage 5.
Programming a new (individual, group or general) control point
5
5.1- Open the memory of the receiver from the control
transmitter:
- Press the "PROG" key of the transmitter for about 3
seconds. The motor will run for 0.5 second in one
direction and then in the other.
5.2- Confirm the operation from the new transmitter
you want to program:
- Press the «PROG» key of the transmitter for 1 second.
The motor will run for 0.5 second in one direction and
then in the other.
- For group controls, repeat operations 5.1 and 5.2 for each motor in the group.
- For general controls, repeat operations 5.1 and 5.2 for each motor in the installation.
- To delete an transmitter from the memory of a motor, perform operations 5.1 with a programmed transmitter,
then perform the operation 5.2 with the transmitter to be deleted.
Recording / controling / deleting intermediate position
6
Recording:
- Move the motor to the wanted
position.
- Press 5 seconds on the
"Stop" key. The motor will run
for 0.5 second in one direction
and then in the other.
Deleting: Position the motor on the intermediate position. Press 5 seconds on the "Stop" key, the intermediate
position is deleted. The motor will run for 0.5 second in one direction and then in the other.
i
The intermediate position is only accessible once the motor has found its end limits (6 cycles max.).
Modification of the rotation direction (in user mode):
7
Do not move the roller shutter to the up or down end limit
position.
7.1- Press the "Up" and "Down" buttons simultaneously for
5 seconds. The motor runs briefly in one direction, then in the
other.
7.2- Within 2 seconds, press the Stop button for 2 seconds. The
motor briefly runs in one direction, then in the other. The rotation
direction has been changed.
i
After stage 7.1, if no operation is carried out before 2 seconds, the motor runs again briefly in one direction
and then in the other, and the rotation direction is not changed.
1
2
1
2
Control:
- Press the
key for 0.5 second.
The motor runs to the
intermediate position.
5s
1
>>
PROG 1s.
>>
PROG ≥ 3s.
>>
PROG < 1s.
«Stop»
0,5s
7.1
5s
2s
7.2
2s
EN
3/4