Before First Use - Klarstein 10028327 Bedienungsanleitung

IMPORTANT: The special plastic hose support must be solidly fastened to the wall to prevent the drain hose
from moving and allowing water to spill outside the drain.
Drain Excess Water
If the sink is 1000 higher from the floor, the excess water in hoses cannot be drained directly into the sink. It
will be necessary to drain excess water from hoses into a bowl or suitable container that is held outside and
lower than the sink.
Extension Hose
If you need a drain hose extension, observe to use a similar drain hose. It must be no longer than 4 metres;
otherwise the cleaning effect of the dishwasher could be reduced.
The following things should be checked before starting the dishwasher.
• The dishwasher is level and fixed properly.
• The inlet valve is open.
• The wires are tightly connected.
• The power is switched on.
• The inlet and drain hoses are knotted.
• All packing materials and printings should be taken out from the dishwasher.
Loading the Salt into the Softener
• Only use salt specifically designed for use in dishwashers! All other types of salt not specifically designed
for use in a dishwasher, especially table salt, will damage the water softener. in case of damages caused by
the use of unsuitable salt the manufacturer does not give any warranty nor is liable for any caused damages.
• Only fill with salt just before starting one of the complete washing programmes. This will prevent any grains
of salt or salty water, which may have been split, remaining of the bottom of the machine for any period of
time, which may cause corrosion.
How to load the Salt:
25

Before first Use