Midea MEK45TBL Gebrauchsanleitung Seite 54

04
INSTALLATION
▲ Fitted units
1. This appliance is only intended to be fully fitted in a kitchen.
2. This appliance is not designed to be used as a tabletop appliance
or inside a cupboard.
3. The fitted cabinet must not have a back wall behind the appliance.
4. A gap of at least 45 mm must be maintained between the wall and
the base or back panel of the unit above.
5. The fitted cabinet must have a ventilation opening of 250 cm
on the front. To achieve this, cut back the base panel or fit a
ventilation grille.
6. Ventilation slots and intakes must not be covered.
7. The safe operation of this appliance can only be guaranteed
if it has been installed in accordance with these installation
instructions.
8. The fitter is liable for any damage resulting from incorrect
installation.
9. The units into which the appliance is fitted must be heat-resistant
up 90 °C.
Installation height not less than 850mm.
▲
Installation dimensions
Note: There should be gap above the oven.
min 45
Ventilation grid Cupboard feet
EN-10
min 6
460
2
50
250