Switching On/Off; Soldering Sponge - Parkside Plsa 20 Li B2 Bedienungs- Und Sicherheitshinweise

Switching off
NOTE
After use, always put the soldering iron
u
holder .
[ 3 ]
After the status LED
u
iron in the holder
[ 1 ]
o
When the product is not in use, remove the battery pack
o
˜ Soldering sponge
m ATTENTION!
The hot soldering tip
u
dry soldering sponge
could be damaged .
NOTE
The soldering sponge
u
Dampen the soldering sponge
u
has gone out, leave the soldering
7 ] [
for at least 30 minutes to cool down .
[ 3 ]
Press the on/off switch
red slowly for approx . 10 minutes . This is the
cool-down mode . The cool-down mode is intended to
warn the user that the soldering iron
must never come into contact with a
[ 11 ]
. Otherwise, the soldering sponge
2 ] [
is used to clean the soldering tip
2 ] [
back into the
1 ] [
. The status LED
6 ] [
before use .
2 ] [
flashes
7 ] [
is still hot .
1 ] [
.
5 ] [
.
11 ] [
GB 17