Werbung
Verfügbare Sprachen
Verfügbare Sprachen
For the automatic backlight function, the sensitivity of Che light sensorcan be adjusted to high
ox low with the sensitivity switch also on the back of the Main Unit
Note: Main Ulilt must be powered withAC/DC adaptor for automatic backlight control
function
4 LINKING
THE
WEATHER
STATION
Data collected by the weather station can be displayed and recorded on a eomputer by
connecting the main console unit with the computer via USB-
Install the software provided with the weather station according to the instructions on the
Connect the Main Unit with the computer using the USB cable provided aher installmg the
soft-are
and the complete setting up of the weather statin
S MAINTENANCE
CHANGING
RATTERIES
If the
battery indicators light up,
immediately,
Batter:' Replacement
• Use alkaline batteries only. Observe correct polarity. Low batteries should be changed soon to
avoid the damage result14g from a leaking battery. Batteries contain hamftl
protective glasses aud gloves whell handling damaged batteries.
Caution: Pleasedo cot dispose of old electronic devices and empty batteries in
hou•ehcld waste.To protect the environment, take them to your retail stcxeor to
appmpnate collection sates according to national Of local regulations.
CHANGING
BATTERIES
FOR
THE
REMOTE
l, Replace the
following
the setup
2. When the batteries are properly installed. the sensor will resume sending signals to the main
console
unit.
To enforce a searchimmediately for all remote signals, pressand hold [
back of the Main
CLEANING
The Main Uinit and outer casings for the remote sensors can be cleaned with a damp cloth
Small parts -canbe Cleaned With
cotton tip Ot
Never use any abrasive clearnng agenis and solvents. Do nol immerse any units WI(h electronic
parts in water or under running water.
TO
A COMPUTER
the batteries for the corresponding
Wear
SENSORS
for the corresponding sensor,
located at the
66
ANEMOMETER
• Check
theWind
Wind
RAIN
GAUGE
Like all rain gauges, the rain sensor is prone to blockages duc to its funnel shape. Checking and
cleaning thc rain sensor from time tu time will maintain the accuracy of rain measurements.
•
Detach
protective
lid. Remove any dirt, leaves
soapy yatcr and a
cloth. Clean small holes and parts with a cotton tips or pipe-cleaner.
•
I ,ook out for spiders or insects that might have crawled into the funnel.
TROUBLESHOOTING
'Thc display shows dashes
for weather parameter(S)"
The display will show '4
when
the
wireless
following
periods:
Thertt'i0-hygro
Sensor
I
Anemometer
(Wind
Sensor)
— 15 nunutes
Rain Sensor
— 30 minutes
Check or replace the batteries for the corresponding se]isor, men press and hold [
the back of the Malti Unit 10 enforce a search Ior all retnote signals,
If the above does not solve the problem, check the wireless transmission path frorn the
corresponding sensorto the main console unit and changetheir locations if necessary.
Although wireless signals can pass through solid objects andwalls, the sensor should ideally be
within the line or sight of the console unit,
The following may be the causeof reception prob ems;.
Distance between remote sensorand main console unit too long.
Signal shielding materials such as metal surfaces,
path of transmission
• Interferences frorn wireless devices (such as cordless phones,radio headsets,baby listening
devices) and eleetronie appliances.
PRECAUTIONS
This product is engineeredto give you years of satisfactory service if you handle it carefully.
Here are a few precautions:
l, Do not immerse the unit in water,
2, DO
the unit
abrasive or corrosive materials, They
and corrode
the electronic
cireuut.
3. Do not subject the unit to excessiveforce, shock, dust, temperature oxhumidity, which may
result in malfunction, shorter electronic life span, damagedbattery and distorted parts,
4, Do not tamper Wlth the
internal components_ Doing so will invalidate the warranty on
the unit and may cause unnecessary damage. The unit contauns no user-serviceable parts.
5. Only use fresh batteries as specified in thc user's manual. Do not mix new and old hatterics
as the old ones may leak-
6. Always read the users manual thoroughly before operating the unit.
spinfreely
debris by cleaning
link
is last
with
the remote
sensor
inr
the
t'titnutes
I located at
walls Of
vegetation in the
the Plastic parts
67
with
Werbung
