Werbung
Verfügbare Sprachen
Verfügbare Sprachen
3, Set Sea-Level
Pressure Units:
press [ SET ] until Sea—Level pressure is displayed
Pressand hold I MEMORY
[ A I OT[ V I to adjust the unit (hPafmBar, mmHg, InHg)
Prcss [ MEMORY
to confirm your selection.
SETTING
PRESSURE
PARAMETERS
During the initial start-up of the Main UniL the pressure settingsshould be configured in
following
steps-
l,
Choose
Pressure
Units:
The unit Icon "inHe" or
or ''hPa\mBa€' should be flashing- [
pressure unit as LnHg, hPa.hnBzr or mrnHg
Press [ SET
to confirm your sclcetion.
2.
Choo«e
Altitude
Units;
Press IA
I or [V
I to select altitude unit as feet or meters.
Press[ SET to confirm your selection.
3.
Set Altitude:
I A J or [ V Ito adjust value. Press and hold either button for fast advance.
Press[ SET to confirm you.rselection.
4_ Upon completion,
display
be
VIEWING
THE SEALEVEL
PRESSURE
L In all modes, pressing I HISL)RY
J will toggle the sca level pressurc display.
X Whcn sca lcvcl pressurc is displaycd. press [ HISTORY ] rcpcatcdly to vicw scalcvcl
pressuredata for eachof the last 24 hours.
3. If no buttons are pressed for 5s the display automatically show the current pressure
VIEWING
PRESSURE/TEMPERATURFJ
The bar-chart
the display
be configured to display Lhehistory data
lernperature or humidity ror channel 1.
In PressureMode. press andhold [ ALARM/CHART
• Sea-level prcssurc ("PRESSURE" should hedisplayed)
• Tcmpcraturc (Thc:rmomctcr icon and
Humidity (RH icon and "CH l" should be displayed)
DURING
INITIAL
START-UP
or
to pressure andWeather
HISTORY
BAR-CHARTS
sea—levelpressure,
I to toggle the bar-chart between:
" should bc displayed)
VIEWING
MOON
PHASE
L In Pressure Mode, press [ MEMORY
2. "+0 days" should bc flashing.
3. View Monn PhaseHistory Forecast:
[
I or [ Y] to choose number of days forward (+ days) or backward
date. Press and hold either button for fast advance.
The corresponding moon phasewill be shown
4,
I MEMORY],
Otherwise, if
Weather
Forecast
Mode.
to select
UNDERSTANDING
C)
FULL
LAST
:.4.:
TEMPERATURE
The weather station supports up to 5 remote thermo-hygrometer
corresponding to
separate channel for the temperature and relative humidity display, The
temperature rnay be shown in degreesCelsius
steadyor felling) of all values is also indicated on thc display.
Thc Main Unit usesthe indoor temperature and humidity data to compute a comfort level rating
of Wet, Cornfort or Dry.
A temperature alert function is available for all rhanne1E- [t can be programmed to sound if ane
channel temperature
Note: The
constantly due to
reaches the alertvalue,it will haveto fall below thealert valueplusthe hysteresis to deactivate
the alert.
HISTORY
AND
FORECAST
l.
pressed
5s
display automatically
THE
MOON
PHASE
DIAGRAM
NEW
FIRST
HUMIDITY
PARAMETERS
or degreesFahrenheit OF. T hc trend (rising,
or falls below the
upper and lower limit.
alert has a
"C hysterests
prevent Chealerts
fluctuations
the alert value, This
59
days) from current
to Ptessuteand
sensors, each sensor
that
the temperature
Werbung
