Werbung
Cleaning of the sensor buttons
❖ Contamination / soiling of the sensor buttons: the appliance may beep and
switch off automatically. The sensors may not work properly when they are wet.
Dry the control panel carefully before you put it into operation again.
1. Disconnect the appliance from the mains (fuse-box).
2. Wipe the sensors with a damp sponge or cloth.
3. Dry the sensors with kitchen paper.
4. Connect the appliance to the mains again.
NOTICE! Dry the control panel carefully and thoroughly before you put it
into operation again.
8. Trouble shooting
DANGER!
Never try to repair the appliance yourself. Repairs carried
out by unauthorised persons can cause serious damage. If the appliance
does not operate properly, please contact the aftersales service or the
shop you purchased the appliance at.
1. Switch off the entire appliance.
2. Disconnect the appliance from the mains (fuse box of your household power
supply).
3. Contact your aftersales service or the shop you purchased the appliance at.
➢ Check the table below before you contact your aftersales service or the shop you
purchased the appliance at: see page « S
Depending on model: s. page « S
12
12
E
MERGENCY MEASURES
ERVICE INFORMATION
~
~
ERVICE INFORMATION
88
».
» at the end of this instruction manual.
Werbung
