Installation - Electrolux EUC05002W Benutzerinformation

6 electrolux
The technical information are situated in the rat-
ing plate on the internal left side of the appliance
and in the energy label.

INSTALLATION

Caution! Read the "Safety Information"
carefully for your safety and correct
operation of the appliance before installing the
appliance.
Positioning
This appliance can be installed in a dry, well ven-
tilated indoor (garage or cellar) also, but for opti-
mum performance install this appliance at a loca-
tion where the ambient temperature corresponds
to the climate class indicated on the rating plate
of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Rear spacers
In the bag with the documentation, there are two
spacers which must be fitted as shown in the fig-
ure.
Using fine strokes of hammer put them in their
place.
Location
The appliance should be installed well away from
sources of heat such as radiators, boilers, direct
sunlight etc. Ensure that air can circulate freely
around the back of the cabinet. To ensure best
performance, if the appliance is positioned below
an overhanging wall unit, the minimum distance
between the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however, the
appliance should not be positioned below over-
hanging wall units. Accurate levelling is ensured
by one or more adjustable feet at the base of the
cabinet.
If the cabinet is placed in a corner and the side
with the hinges facing the wall, the distance be-
tween the wall and the cabinet must be at least
10 mm to allow the door to open enough so that
the shelves can be removed.
Warning! It must be possible to
disconnect the appliance from the mains
power supply; the plug must therefore be easily
accessible after installation.
A
Door reversibility
Important! To carry out the following
operations, we suggest that this be made with
another person that will keep a firm hold on the
doors of the appliance during the operations.
To change the opening direction of the door, do
these steps:
1. Remove the plug from the power socket.
2. Remove the top hinge cover.
3. Unscrew the 2 retaining screws, and remove
the hinge from the appliance.
B