Technical Data; Installation - Electrolux EUF10003W Benutzerinformation

20 electrolux
Problem
Green indicator flashing
Closing the door
1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "In-
stallation".

TECHNICAL DATA

Dimension
Rising Time
The technical information are situated in the
rating plate on the internal left side of the ap-
pliance and in the energy label.

INSTALLATION

Read the "Safety Information" carefully
for your safety and correct operation of
the appliance before installing the
appliance.
Positioning
This appliance can be installed in a dry, well
ventilated indoor (garage or cellar) also, but
for optimum performance install this appli-
ance at a location where the ambient tem-
perature corresponds to the climate class in-
dicated on the rating plate of the appliance:
Climate Ambient temperature
class
SN +10°C to + 32°C
N +16°C to + 32°C
ST +16°C to + 38°C
T +16°C to + 43°C
Levelling
When placing the appliance ensure that it
stands level. This can be achieved by two
adjustable feet at the bottom in front (2). If
necessary adjust the feet by removing the
spacer (1).
Downloaded from Fridge-Manual.com Manuals
All manuals and user guides at all-guides.com
Possible cause
Temperature Regulator is not on
Temperature sensor problem
3. If necessary, replace the defective door
Height
Width
Depth
Location
The appliance should be installed well away
from sources of heat such as radiators, boil-
ers, direct sunlight etc. Ensure that air can
circulate freely around the back of the cabi-
net. To ensure best performance, if the ap-
pliance is positioned below an overhanging
wall unit, the minimum distance between
the top of the cabinet and the wall unit
must be at least 100 mm . Ideally, however,
the appliance should not be positioned be-
low overhanging wall units. Accurate level-
ling is ensured by one or more adjustable
feet at the base of the cabinet.
Solution
Check the Temperature Regulator
Call the service personnel
gaskets. Contact the Service Center.
850 mm
595 mm
635 mm
13 h
1
2